IconBiT K7, User Manual, Page: 3 / 44

English 1/6
1. Overview
10
11
12
13
14
15
16
1
2
3
4
5
8
6
7
9
1. Brake
2. Saddle
3. Seat post clamp
4. Battery
5. Indicator light
6. Power switch
7. Taillight
8. Back interpolation
2. Installation
1. Lift the steering rod
to vertically.
2. Close the Quick release
lever to fix the steering rod.
3. Unfold the frame and lock
the quick release.
Note: To unlock the frame quick rele-
ase clamp push the lock-pin and pull
the quick release clamp.
4. Put down the kick stand /
bicycle stand.
5. Adjust the steering rod height: release the quick release
and lift the handlebar stem up to an ideal height and
tighten the handlebar stem by closing the quick
release clamp.
6. Straighten the handlebars: release the quick release clamp,
rotate the handlebar to a suitable position and lock into
place. Tighten the handlebar by using the quick
release clamp.
7. Adjust the saddle height by opening the quick release
seat post clamp. Lift the saddle up to an ideal height and
a suitable position. Lock the quick release seat post clamp.
Note:
An ideal height is provided when the knee is at a soft bend while
sitting on the saddle and your foot placed on the pedal at its lowest point.
8. Installing the pedals:
• Note the left and right of the pedal.
• [L] left [R] right are stamped on the threaded end of the pedal.
• Attach the L pedal to the L crank, then R pedal to R crank.
• Screw the pedals in and tighten them fully.
Note:
Pedals can be folded for a better transportation. To fold the pedal gently press the pedal against
the frame and bend it down. To unfold the pedal just pull the pedal upwards till it clicks into place.
Caution: The L pedal has left-hand threads, and the R pedal has right-hand threads. Damages caused
due to improper installation are not covered by the warranty.
L R
IMPORTANT NOTES:
• Always read the operating instructions attentively before first use. You will become familiar with your E-bike more quickly that way
and can avoid wrong operation leading to damage or accidents. Specifically follow the safety and danger notes.
• The E-bike was delivered in the preinstalled condition. Before initial commissioning,it is therefore mandatory that the E-Bike be set,
adjusted and checked for tight fit of the components and screws.
9. Kickstand
10. Instrument panel
11. Vertical pipe clamp
12. Handlebar folded lock
13. Folding handle
14. Pedal
15. Front interpolation
16. Front wheel