6
Front Panel
1. “Mic/Inst” Inputs 1/2
Unbalanced instrument and mic level inputs. These hybrid connectors will accept a
standard 3-pin XLR plug or a 1/4” TS connector.
2. Clip LED
When lit, this LED indicates clipping input level at the associated Mic/Inst input.
The LED will illuminate when the signal is 3dB below the clipping point.
3. Signal LED
When lit, this LED indicates the presence of an audio signal at the associated
Mic/Inst input.
4. 48V phantom power switch
When this switch is in the IN position, +48V phantom power is supplied to the XLR
input. This phantom power circuit is suitable for most condenser microphones.
5. Input gain level controls 1/2
This potentiometer controls the input level of its associated analog
Mic/Instrument/Line input.
6. Hardware / PC Monitoring Control
Hardware direct monitoring ( Clockwise - "Direct Out" ) eliminates the latency or
delay inherent in even the best internal circuitry while listening to your input and
existing tracks. You can also listen to your input complete with effects (Counter-
Clockwise - "PC") while recording by using extremely the low-latency ASIO
monitoring.
7. Headphone output
The output jack accepts a standard 1/4" stereo TRS headphone connector with
individual level regulated by the HEADPHONE LEVEL CONTROLS. The default
source selection for the headphone output is identical to line outputs 1/2.
8. Headphone level control
The potentiometers controls the output level of the headphone output.
9. Power switch
This switch controls the overall power to the unit.
6
7
9
4
5
1
8
3
2
