23
Inspect and tighten all parts of the exercise cycle reg-
ularly. Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and a
small amount of mild soap.
IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
If the console display becomes dim, the batteries
should be replaced; most console problems are the
result of low batteries. See assembly step 5 on page 8
for replacement instructions. If the handgrip pulse sen-
sor does not function properly, see step 5 on page 15.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, you must first remove the left pedal and the
left front shield. Using an adjustable wrench, turn the
left pedal clockwise and remove it. Next, remove all
the screws from the left and right front shields;
there
are two sizes of screws in the front shields–note
which size of screw you remove from each hole.
Then, gently pull the left front shield away from the
frame.
Locate the Reed Switch (46). Turn the Pulley (29)
until a Magnet (30) is aligned with the Reed Switch.
Next, loosen, but do not remove, the indicated M4 x
16mm Screw (57). Slide the Reed Switch slightly
closer to or away from the Magnet, and then retighten
the Screw. Turn the Pulley for a moment. Repeat
these actions until the console displays correct feed-
back. When the Reed Switch is correctly adjusted,
reattach the front shields and the left pedal.
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while
the resistance is adjusted to the highest setting, the
drive belt may need to be adjusted. To adjust the drive
belt, you must first remove the right pedal and the
right front shield. Using an adjustable wrench, turn the
right pedal counterclockwise and remove it. Next,
remove all the screws from the left and right front
shields;
there are two sizes of screws in the front
shields–note which size of screw you remove from
each hole.
Then, gently pull the right front shield
away from the frame.
Loosen, but do not remove, the three indicated screws
(A). Insert the shaft of a screwdriver downward
between the Idler (B) and the Idler Pulley (38). Pull the
top of the screwdriver toward the rear of the exercise
cycle until the Drive Belt (47) is tight. Tighten the three
screws. Then, reattach the front shields and the right
pedal.
MAINTENANCE AND TROUBLESHOOTING
46 57
29
30
A
B
38
47
