11
9
93
I
9
5
9. IMPORTANT: To avoid damaging the Pulse
Crossbar (93), do not use power tools and do
not overtighten the #10 x 3/4" Screws (9).
Attach the Pulse Crossbar (93) to the right hand-
rail assembly (I) and the left handrail assembly
(not shown) with four #10 x 3/4" Screws (9)
and four #10 Star Washers (5) (only one side
is shown); start all of the Screws, and then
tighten them.
G
N
M
L
10. With the help of a second person, hold the
console assembly (L) near the console base
assembly (G).
See the inset drawing. Connect the wire (M)
from the console base assembly (G) to the
wire (N) from the console assembly (L). The
connectors should slide together easily and
snap into place with an audible click. If they
do not, turn one connector and try again.
Next, locate the console wire (O) in the console
assembly (L). Connect the console wire to the
Upright Wire (81). The connectors should
slide together easily and snap into place
with an audible click. If they do not, turn one
connector and try again. Then, remove the
wire tie (A).
Then, insert the wires (M, N) into the hole in the
Console Base (64). Insert the wires (O, 81) into
the console assembly (L), and position the wires
on the decal.
M
N
81
A
64
O
10
