ICON ITSWC56R, Owner'S Manual & Safety Instructions

Page: 12 / 20

Page 4
WORKCENTER HUTCH
For technical questions, please call 1-888-866-5797.
4. WARNING! TO PREVENT SERIOUS INJURY
AND DEATH FROM ELECTRIC SHOCK,
unplug power cord from Roll Cab before
drilling holes into the Stainless Steel Top.
5. Place the included hole Template firmly against
one end of the Stainless Steel Top.
6. Use a punch and hammer (both sold separately)
to create a centered pin point for drilling by aligning
punch and hitting the end of it with a hammer
in the 2 hole locations on the template.
punch
(sold separately)
Template
Stainless Stainless
Steel Top Steel Top
(sold separately) (sold separately)
Figure B:
7. Set the Template aside.
8. Use a Drill and 13/64″ Drill Bit (both sold separately) to drill
1″ deep holes straight down into the Top where marked.
CAUTION! Do not drill holes deeper than 1″.
Stainless
Steel Top
drill and bit
(sold separately)
punched
hole
Figure C:
9. Repeat steps 5 through 8 for the other
end of the Stainless Steel Top.