ICON inspire 5G2, User Manual

Page: 21 / 42

21
Diagram 11
Note:
You may activate the four VirtualPort™ & the MIDI Out port for each zone,
so that its message will be send to the activated port(s). To activate, “check” the
corresponding check box.
2. Pad – Assign the MIDI function to your InSpire G2’s drum-
pads
Send Data Send Data
Exit Exit
Send Data Send Data
Exit Exit Firmware Upgrade Firmware Upgrade
Layer1
Layer2
Layer3
Layer4
Mode
Chan
Vel
CC
Vale2
All
Device1
Device2
Device3
Device4
MIDI Out
All
Send Data Send Data Exit Exit Send Data Send Data Exit Exit
Firmware Upgrade Firmware Upgrade
Layer1
Layer2
Layer3
Layer4
Mode
Chan
Vel
CC
Vale2
All
Device1
Device2
Device3
Device4
MIDI Out
All
Send Data Send Data Exit Exit Send Data Send Data Exit Exit
Firmware Upgrade Firmware Upgrade
Y
x
Y
x
Mode
Device1
Device2
Device3
Device4
MIDI Out
CH
Note
Down Vale
Up Vale
Led return back
select button
All
Encoder1 Encoder2 Encoder3 Encoder4 Encoder5 Encoder6 Encoder7 Encoder8
Y
x
Y
x
Y
x
Y
x
Octave
Transpose
Chan Vel Start End
Global
ZONE1
ZONE2
ZONE3
ZONE4
MIDI Out Device1 Device2 Device3 Device4
Send Data Send Data Exit Exit Send Data Send Data Exit Exit
Firmware Upgrade Firmware Upgrade
Octave
Transpose
Chan Vel Start End
Global
ZONE1
ZONE2
ZONE3
ZONE4
MIDI Out Device1 Device2 Device3 Device4
Send Data Send Data Exit Exit Send Data Send Data Exit Exit
Firmware Upgrade Firmware Upgrade
There are 12-pads with four layers (48-pads in total) that you can assign a midi
function independently. To assign a pad, click it (it will turn blue), and select the
function on the left table as described below.
There are 3 different modes for selection including “Note”, “Control” and
“Programme”. Each mode has its own midi message and setting as the table
below shows.
Mode Settings Value Description "All" Check box
Note
Channel 1 to 16
Set the midi channel of
the correspondence pad
Check this box to assign
the selected channel to
all the 16-pads at the
correspondence layer
Velocity
+1 to
+12
Set the velocity curve of
the correspondence pad
Check this box to assign
the selected velocity to
all the 16-pads at the
correspondence layer
Note
-1(C) to
9(G)
Set the note value of the
correspondence pad
-