ICON A5, Maintenance Manual, Page: 75 / 836

INSPECTIONS / CONDITION INSPECTIONS AND 100-HOUR INSPECTIONS 3-23
CHANGE C2 ICON A5 / MAINTENANCE MANUAL
CHA
P
TER
3
3.3.9 Condition and 100-Hour Inspection—Avionics and Electrical
Correct all unsatisfactory items prior to flight
S=Satisfactory, U=Unsatisfactory
S U Comments
Battery, load test, free of corrosion, secure
Perform ELT inspection/functional check per FAR 91.207.
See “ELT Inspection and Function Check” on page 13-44.
Inspect antenna mount and wiring for security
Check wires to battery ground
Inspect radio/leads/wires for attachment and security
Inspect wiring instrument panel for attachment and
security
Check bilge pump for function, clear of debris.
See “Check Bilge Pump Function” on page 6-42. See
“Bilge Pump Debris Removal” on page 7-6.
Check wiring harness for chafing/security/condition.See
“Inspect, Repair, and Secure Wiring Harness with Signs of
Chafing” on page 6-34.
Check for wire/connector strains
Calibrate AOA pressure transducer. See “Calibrate AOA
Pressure Transducer” on page 13-25.
Verify regulator B fan is operating with master power
turned on
Inspect regulator B wires for browning near connector.
See “Inspect Regulator Wires” on page 16-84.
Inspect regulator A wire for browning near connector. See
“Inspect Regulator Wires” on page 16-84.
Inspect Rotax fuse box for blown fuses and correct sized
fuses are installed
Inspect overhead panel for blown fuses and correct sized
fuses are installed.
See “Replace Overhead Console Fuses” on page 13-18.