ICON A5, Maintenance Manual, Page: 212 / 836

7-6 ENVIRONMENTAL CONTROL (UTILITY SYSTEMS) / MAINTENANCE INSTRUCTIONS
ICON A5 / MAINTENANCE MANUAL CHANGE C1
CHA
P
TER
7
7.3 Maintenance Instructions
7.3.1 Bilge Pump Debris Removal
The following section includes information necessary to check the bilge pump for debris.
T
ASK
I
NFORMATION
:
Type of Maintenance
Line
Level of Certification
Owner/Pilot
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
04—Environmental Control (Utility Systems)
Consumables
None
T
ASK
I
NSTRUCTIONS
:
1. Remove the 4 Torx #20, 10-32 thread flat head screws of the right baggage floor panel.
2. Remove the right baggage floor panel. (See “Baggage Floor Removal” on page 3-41.)
3. With a flashlight, place the light beam in the middle-rear of the fuel bladder installation looking
down to the bottom of the fuselage.
4. Inspect the bilge pump. If there is any debris, gently remove from around the screen portion of
the pump.
5. Replace the right baggage floor panel. (See “Baggage Floor Installation” on page 3-42.)
6. Tighten and secure the 4 Torx #20, 10-32 thread flat head screws.
R
ELATED
I
NFORMATION
:
"Condition and 100-Hour Inspection—Avionics and Electrical" on page 3-23