1
7929 Lincoln Ave. Riverside, CA 92504
Phone: 951.689.ICON Fax: 951.689.1016
PART #
DESCRIPTION
54000T
2007-UP FJ/4RUNNER TUBULAR LOWER
TRAILING ARM KIT
54000T INSTALLATION INSTRUCTIONS
WARNING!
** READ ALL INSTRUCTIONS THOROUGHLY FROM START TO FINISH
BEFORE BEGINNING INSTALLATION! IF THESE INSTRUCTIONS ARE
NOT PROPERLY FOLLOWED SEVERE FRAME, SUSPENSION AND TIRE
DAMAGE MAY RESULT TO THE VEHICLE!
** ICON VEHICLE DYNAMICS RECOMMENDS THAT YOU EXERCISE
EXTREME CAUTION WHEN WORKING UNDER A VEHICLE THAT IS
SUPPORTED WITH JACK STANDS.
** ICON VEHICLE DYNAMICS RECOMMENDS ALL INSTALLTION TO
BE PERFORMED BY A PROFESSIONAL SHOP/SERVICE TECHNICIAN.
PRODUCT FAILURE CAUSED BY IMPROPER INSTALLATION WILL NOT BE
COVERED UNDER ICON’S WARRANTY POLICY.
1.
Using a properly rated jack, raise the rear of the vehicle and support the frame rails with jack stands. Ensure the jack stands are
secure and set properly before lowering the jack. NEVER WORK UNDER AN UNSUPPORTED VEHICLE. Remove the rear wheels
NOTE: REMOVE AND REPLACE ONLY ONE FACTORY LINK ARM AT A TIME.
2
. Lay ICON link arm over the factory link to set a starting point for adjustment (26.75”).
3
. Use the factory hardware to install the link arm on the axle end using a 19mm socket/wrench. [Torque to factory spec]
[FIGURE 1 & 2]
COMPONENTS INCLUDED
(1) 154400 07-UP FJ/4RUNNER TUBULAR LOWER
TRAILING ARM (DRVR)
(1) 154401 07-UP FJ/4-RUNNER TUBULAR LOWER
TRAILING ARM (PASS)
HARDWARE INCLUDED
(2) 127005 HEIM SPACER JM16 X .570 X 2.625
(2) 157430 HEIM SPACER JM16 X .570 X 2.075
(2) 295510 JM16-1T 1-14 RH ROD END F1 FIT
(2) 297102 GREASELESS PRESS IN BUSH 2.135 X
14.3MM X 58.85MM
(2) 605920 1-14 JAM NUT
TOOLS REQUIRED
JACK
JACK STANDS
TORQUE WRENCH
1.5” OPEN END WRENCH
12MM SOCKET / WRENCH
19MM SOCKET / WRENCH
21MM SOCKET / WRENCH
TECH NOTES
1. DO NOT EXCEED 3.5” FROM LINK FACE TO CENTERLINE OF ROD END.
2. BUSHINGS ARE GREASELESS AND DO NOT REQUIRE MAINTENANCE.
3. LOWER ARMS MOUNT SO THAT THE REAR BUSHING HOUSING IS TANGENT WITH THE TUBE ON
BOTTOM. IF MOUNTED UPSIDE DOWN, LINK TUBE WILL BIND ON AXLE HOUSING.
6-01-2016 REV.A
INSTALLATION
FIG.2
FIG.1
