32
b.
If the walking belt slips when walked on,
fi
rst
remove the key and
UNPLUG THE POWER
CORD.
Using the hex key, turn both idler roller
screws clockwise, 1/4 of a turn. When the walk-
ing belt is correctly tightened, you should be able
to lift each edge of the walking belt 2 to 3 in. (5 to
7 cm) off the walking platform. Be careful to keep
the walking belt centered. Then, plug in the power
cord, insert the key, and walk on the treadmill for a
few minutes. Repeat until the walking belt is prop-
erly tightened.
SYMPTOM: The displays of the console do not
function properly
a.
If the console does not boot up properly, or
if the console freezes and does not respond,
reset the console to the factory default settings.
IMPORTANT: Doing this will erase all the
custom settings you have made to the console.
Resetting the console requires two people. First,
press the power switch into the off position. Next,
locate the small reset opening (D) on the back
edge of the console. Using a bent paper clip (E),
press and hold the reset button inside the opening,
and have a second person press the power switch
into the on (reset) position. Continue holding the
reset button (D) until the console turns on. When
the reset operation is complete, the console will
turn off and then turn back on. If it does not, use
the power switch to turn the treadmill off and then
on again. Once the console turns on, check for
fi
rmware updates (see step 5 on page 25). Note: It
may take a few minutes for the console to be ready
for use.
b
a
D
E
