10
7
7. Have a second person hold the Handlebar (5)
near the Upright (4).
See the inset drawing. Route the Upper Wire
(87) through the Pivot Post (78) and the Pivot
Bracket (71) as shown. Tip: It may be easier to
route the Upper Wire if you adjust the angle
of the Pivot Bracket by turning the Console
Knob (77).
Tip: Avoid pinching the wires. Insert the Pivot
Post (78) into the Upright (4).
Attach the Pivot Post (78) with two M8 x 50mm
Bolts (70) and two M8 Locknuts (43); make
sure that the Locknuts are in the hexagonal
holes (A).
4
71
43
70
78
87
87
71
78
77
5
A
Avoid pinching
the wires
77
8
87
61
13
72
71
72
72
Avoid pinching
the wires
8. Have a second person hold the Console (13)
near the Pivot Bracket (71). Connect the Upper
Wire (87) and the Pulse Wires (61) to the
matching wires or receptacles on the back of the
Console.
If you do not connect the Wires (61, 87)
properly, the Console (13) may become
damaged when you use the exercise bike. If
a connector on a Wire does not slide easily and
snap into place, turn the connector and try again.
Insert the excess wire downward through the
Pivot Bracket (71). Do not insert the excess
wire into the Console (13); the wires may
interfere with the fan.
Tip: Avoid pinching the wires. Attach the
Console (13) to the Pivot Bracket (71) with four
M4 x 16mm Screws (72); start all the Screws,
and then tighten them. Tip: It may be helpful
to adjust the angle of the Pivot Bracket by
turning the Console Knob (77).
77
