7
ASSEMBLY
Assembly requires two persons.
Set the treadmill in a cleared area and remove all packing materials.
Do not
dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking
belt is coated with high-performance lubricant. During shipping, some lubricant may be transferred to the top of
the walking belt or the shipping carton. This is normal and does not affect treadmill performance. If there is lubri-
cant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included hex key and your own Phillips screwdriver
and adjustable
wrench
.
Use the drawings below to identify the assembly hardware. The number in parentheses
below the drawing is the key number of the part, from the PART LIST near the end of this manual. The number
after the parentheses is the quantity needed for assembly.
Note: If a part is not in the hardware kit, check to
see if it is preattached to one of the parts to be assembled. To avoid damaging plastic parts, do not use
power tools for assembly. Extra hardware may be included.
3/8" Star Washer
(90)–10
3/8" x 3 3/4" Bolt (72)–4
3/8" Nut (38)–2
#8 x 3/4"
Tek Screw (29)–4
3/8" x 1 1/4"
Bolt (64)–6
3/8" x 2" Bolt (113)–1
3/8" x 1 3/4" Bolt (117)–1
1.
Make sure that the power cord is unplugged.
With the help of a second person, raise the front
of the treadmill and insert the crossbar on the
Base (83) into the cutout in the cardboard stand
as shown.
Serious injury may occur if the
treadmill moves forward or backward and
falls off the cardboard stand. A second per-
son must hold the treadmill until assembly
step 2 is completed to prevent the treadmill
from moving, tipping, or falling.
83
Cardboard
Stand
1
WARNING:
Serious injury
may occur if the treadmill moves for-
ward or backward and falls off the card-
board stand. A second person must
hold the treadmill until assembly step 2
is completed to prevent the treadmill
from moving, tipping, or falling.
