3
4.
Reject a call
Press and hold “MFB” button for 3 seconds.
5.
Redial the last call
Quickly tap the “MFB” button twice to redial the last dialed phone number.
6.
Play music
Press the “MFB” button to play/pause music under music play status.
7.
Track control
Press and hold the “” button for 2 seconds to skip to the next song. Press and hold the
“volume-” button for 2 seconds to skip to the previous song.
8.
Volume adjust
Press the “” button or the “volume-” button to increase or decrease the volume.
9.
Siri for iPhone
When the headset is not on the phone, click mute switch and you can use Siri for iPhone.
Indicator Light
●
Matching status: red and blue light blinks alternately.
●
The pairing is successful: blue lights flash.
●
Charging status: red light keeps flashing.
●
Charging completed: red light turns off, or blue light keeps flashing.
●
Low-power status: red light turns on with indicate voice.
Bluetooth Headset Connection
Before using your headset for the first time, you must pair it with your Bluetooth-enabled phone.
1. Place the headset within 1 meter with the mobile phone.
2. Ensure that the headset is off ( see “Turn off” in “Basic Operation” section above). And the
mobile phone Bluetooth setting is activated.
3. Press and hold “MFB” button for about 2 seconds until the indicator light alternately flashes
blue and red, now the headset is under pairing mode.
4. Your phone will find the “A12” headset and press “A12” on the mobile phone, after connected
successfully, the headphone will turn to blue light blinking which means the matching is finished.
Now you can listen to the phone music and take a phone call.
5. If your mobile phone is below version 2.1, then you need to enter password “0000” .
Warm Prompt:
1.
Mobile already matched will no need to match again, the headphone will automatically match
the previous device and make connection.
2.
The maximum matching time is no longer than 10 minutes. If you exceeded such time it will
drop out the matching status. If you still can’t match successfully, please repeat the above steps
to match again.
3.
The headphone will automatically shut down when it being no-connection over 11 minutes.
4.
You will hear a voice prompt “disconnected” when you are out of Bluetooth range.
Pairing Your Headset with Two Mobile Phones ( Multipoint Connection)
A12 supports a multipoint function to allow simultaneous pairing of the headset with two mobile
Summary of Contents for A12
Page 1: ...1 ...
