icoms TMA-122, User Manual

Page: 8 / 13

8
2 LED indicator
2.1 I
N NORMAL OPERATION
• The red LED shows the state of the relay 2.
• The green LED shows the state of the relay 1.
2.2 W
HEN THE SELF
-
MONITORING DETECTS AN ERROR
The two LEDs blink quickly (2 or 4 quick flashes followed by a 1 sec break, depending on the detected error).
3 SETTINGS
3.1 ENCODERS
See figures Figure 2and 3, p. 4.
3.1.1 Encoder 1
Besides red LED, at the left facing the housing
Parameter Value Unit
Distance “ movement ” (relay 2) 60 20 m
Distance
“
presence
”
(relay 1)
10 15 10 15 m
Max. relay hold time 2 4 8 16 2 4 8 16 2 4 8 16 2 4 8 16 min
Encoder position 0 1 2 3 4 5 6 7 8 9 A B C D E F
Factory setting = 0
3.1.2 Encoder 2
Besides green LED, at the right facing the housing
Parameter Value
Sensitivity Normal Low
Self - monitoring Active Inactive Active Inactive
RF channel
1 2 3 4 1 2 3 4 1 2 3 4 1 2 3 4
Encoder position 0 1 2 3 4 5 6 7 8 9 A B C D E F
Factory setting = 0
Once you have set the requested radar
parameters, place the sticker on the front face to
guarantee its water tightness.
ATTENTION: manufacturer’s warranty does not
cover radars without sticker!