5
Knowledge Base |
©2021 Icom America Inc. The Icom logo is a registered trademark of Icom Inc.
5.
Go to the
Common
folder and select
Key & Display
.
6.
Set a programmable key to
Scan Start/Stop
. The following example uses the lower side key.
To start a scan:
1.
Switch on the radio power.
2.
Press momentarily (do not hold) the Scan Start/Stop key once to start or stop scan. The
radio LED will blink green while actively scanning.
MDC Signaling
MDC contains signals that enable specific functions, such as PTT ID and Radio Check. It is not used unless
these radios are used in conjunction with a higher-tiered radio with a display and the applicable
functions already programmed.
Assumptions:
•
Software is in Full Mode
•
Squelch is set
•
Any tones are set
•
All participating radios are also programmed for MDC emergency functions.
PTT ID
PTT ID allows your V10MR radio to send its own ID to another radio that has a display. Note: Icom does
not make MURS radios with displays.
1.
Go to
Memory Ch
.
2.
Click
MDC
and select
System 1
.