•
UT-109 and UT-110 scrambler units require some PC
board modifications. (See below and next.)
•
IC-F30/F31GT/GS, IC-F40/F41GT/GS series require
a #02: High AF level type scrambler unit. Do not in-
stall the wrong version, as they are not compatible.
•
The UT-110 may function as the UT-109 through
cloning software.
•
Compatible cloning software: CS-F30G.
APPENDIX -4; IC-F30/F31GT/GS, IC-F40/F41GT/GS SERIES PRECAUTIONS
OPTIONAL UNIT INSTALLATION
M
Installation
Disassemble the some parts before install the scram-
bler unit.
q
Unscrew nut
a
, and remove the knobs.
w
Unscrew screw
b
and 2 screws
c
, then remove
the multi-connector cover and rear panel.
e
Unscrew 2 screws
d
, then remove the multi-con-
nector.
r
Unscrew 2 screws
e
, then take off the chassis from
the front panel in the direction of the arrow.
Be careful!:
Flat cable is connected between the MAIN unit on
the chassis and front panel.
t
Install the desired optional unit. Insert tightly to avoid
bad contact.
NOTE: When installing UT-105 or UT-111, the unit
MUST BE plugged into OPT1. Otherwise the unit
will not work correctly. (Other optional units can be
plugged into either slot.)
y
Program the necessary information with the cloning
software before operation.
• Please refer the “IC-F3GT/GS, IC-F4GT/GS SERIES
CLONING NOTES” on p. 10.
Be sure to resolder disconnected points, otherwise
no TX modulation or AF output is available after you
remove the scrambler units.
NOTE FOR REMOVAL
•
Program the scrambler function ON/OFF/Inhibit and
scrambler codes on the Edit Memory CH screen,
Scrambler type*, Group code*, Synchronous Capture
mode* and Tone Start Timing* on the [Common 2]
screen with cloning software when installing scram-
bler unit. (
*UT-110 only
)
•
Assign the scrambler function to a programmable key
as “Scrambler” on Key & Display Assign screen, if re-
quired.
•
Operation with the [Scrambler] key:
−
Push and hold to turn the voice scrambler function ON.
−
Push to turn the voice scrambler function OFF.
CLONING
OPT1
OPT2
a
b
d
d
c
e
- 12 -
