1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan
A-6656H-1EX
Printed in Japan
© 2008 Icom Inc.
INSTALLATION
ASSEMBLE THE UNIT
• Install the UR-FR5000 or UR-FR6000
(channel extension module)
q
Attach the supplied angles to both sides of the
channel extension module, and tighten the 2 sup-
plied screws (M4
×
8) on each side.
w
Install the channel extension module using the sup-
plied screws (Tapping screws: M3
×
8, Set screws:
M3
×
6) as shown below.
• Connect the control cable
q
Connect the supplied control cable to J502 on the
front board as shown below.
w
Cut the rubber caps of the control cables, then in-
sert the rubber caps to the front panel’s chassis as
shown below.
J502
q
w
Set screws
Tapping
screws
Channel module
(original)
Channel extention
module
Set screws
Tapping
screws
Channel module
(original)
Channel extention
module
q
Replace the rubber seal and shielding plate of the
front panel, then tighten the 6 screws.
• Make sure the rubber seal is properly seated in the
groove of the chassis.
•
Be sure to match the correct positions of the holes of
the shielding plate and projections of the front panel’s
chassis.
w
Connect the control cables to the channel modules.
e
Return the front panel, top cover and screws to
their original positions.
Rubber seal
Holes
Projections
Rubber seal
Holes
Projections
P0
P1
P2
P3
P4
Shorter cable
(lower side)
Longer cable
(upper side)
Channel module
(original)
Channel extention module
P0
P1
P2
P3
P4
Shorter cable
(lower side)
Longer cable
(upper side)
Channel module
(original)
Channel extention module
P0
P1
P2
P3
P4
P0
P1
P2
P3
P4
P0
P1
P2
P3
P4
P0
P1
P2
P3
P4
