This service manual describes the latest technical
information for the
MXG-5000
GPS RECEIVER, at the time
of publication.
NEVER
connect the receiver to an AC outlet or to a DC
power supply that uses more than specified. This will ruin
the receiver.
DO NOT
reverse the polarities of the power supply when
connecting the receiver.
DO NOT
apply an RF signal of more than 20 dBm (100 mW)
to the antenna connector. This could damage the receiver’s
front-end.
To upgrade quality, any electrical or mechanical parts
and internal circuits are subject to change without notice
or obligation.
MODEL
VERSION
MXG-5000
EXP
USA
EUR
Be sure to include the following four points when ordering
replacement parts:
1. 10-digit Icom part number
2. Component name
3. Equipment model name and unit name
4. Quantity required
<ORDER EXAMPLE>
8900018230
OPC-1886
MXG-5000
CHASSIS UNIT
2 pieces
8510012351
2273 U-CASE-1
MXG-5000
CHASSIS UNIT
3 pieces
Addresses are provided on the inside back cover for your
convenience.
ORDERING PARTS
1. Make sure that the problem is internal before
disassembling the receiver.
2.
DO NOT
open the receiver until the receiver is
disconnected from its power source.
3.
DO NOT
force any of the variable components. Turn
them slowly and smoothly.
4.
DO NOT
short any circuits or electronic parts.
5.
DO NOT
keep power ON for a long time when the
receiver is defective.
REPAIR NOTES
INTRODUCTION
CAUTION
Icom, Icom Inc. and the Icom logo are registered trademarks of Icom Incorporated (Japan) in Japan, the United States, the
United Kingdom, Germany, France, Spain, Russia and/or other countries.
