Icom ID
–800H Mini–Operating Guide by W5JCK, September 2007
Page 1 of 6
Icom ID-800H VHF/UHF Radio
Mini
–Operating Guide by W5JCK
1
[
SET●LOCK
]
Set, Lock Switch
● Press to enter Set mode.
● Press and hold for 1 sec. to switch the
Lock function On or Off.
2
[
DIAL
]
Tuning Dial
Turn to select operating frequency, memory
channel, setting for Set mode item, or
scanning direction.
3
[
VOL
]
Volume Control
Turn to adjust audio.
4
[
PWR
]
Power Switch
Press and hold 1 sec. to turn power On/Off.
5
Microphone Connector
Connects the HM-133 microphone.
6
[
SQL
]
Squelch Control
Turn to adjust squelch level.
7
[
MONI●DTMF
]
Monitor, DTMF
● Press to switch the Monitor funct. On/Off.
● During analog operation, press and hold
for 1 second to turn DTMF memory
encoder On or Off.
● During digital operation, press and hold to
turn the EMR function On or Off.
8
[
LOW●DUP
]
Output Power, Duplex Switch
● Press to change the power output level.
● Press and hold for 1 sec. to select
between DUP-, DUP+, and Simplex
operation.
9
[
TONE●T-SCAN
]
Tone, Tone Scan Switch
● During analog operation, press to select a
Tone function.
● During digital operation, press to select a
digital Squelch function.
● During digital operation, press and hold to
turn the Break-in function On or Off.
10
[
M/CALL●PRIO
]
Memory/Call, Priority Sw.
● Press to select between memory, Call, and
Weather Channel modes.
● Press and hold for 1 sec. to start the
Priority Watch operation.
11
[
V/MHz●SCAN
]
VFO/MHz Tuning, Scan Sw.
● Press to select between VFO mode and 1
MHz Tuning mode.
● Press and hold 1 sec. to start/stop scan.
12
[
BAND●MODE
]
Band Switch
● During VFO op., press to select the
operating frequency.
● During Call Channel op., press to select
between call channels 1 or 2.
● During Memory Channel op., press to
select memory bank condition.
● Press and hold for 1 sec. then turn to
select operating mode.
13
[
S.MW●MW
]
Memory Write Switch
● Press to select a memory channel for
programming.
● Press and hold for 1 sec. to program a
memory channel.
