Section
5
7
FRONT PANEL PROGRAMMING
Front Panel Programming mode
The following settings can be changed in the Front
Panel Programming mode without a PC. This is a con-
venient function to immediately change some settings
when you operate the transceiver in the field.
• Receive (RX) and Transmit (TX) frequencies
• RX and TX CTCSS tone frequencies
• RX and TX DTCS codes
• Channel name
NOTE:
While the transceiver is in the Front Panel Program-
ming mode, you cannot receive or transmit.
Entering the Front Panel Programming
D
mode
Rotate
q
[VOL]
to turn OFF the transceiver.
While holding down
w
[P0]
and
[UP]
, turn ON the
transceiver.
• “SET MODE” is displayed.
Push
e
[P0]
to enter the Front Panel Programming
mode.
• A zone number and a channel number are displayed.
To exit the Front Panel Programming mode and return to
the normal operation:
Turn OFF the transceiver.
➥
Selecting a channel to program
D
After a zone and a channel number are displayed, as
q
described to the left, push
[P3]
to enter the Channel
Selection mode.
• The channel number blinks.
Push
w
[P1]
several times to select a zone.
Push
e
[UP]
or
[DOWN]
to select a channel you want
to program.
Push
r
[P3]
again to set the channel.
• The channel number stops blinking.
zone
channel
