This service manual describes the latest service information
for the
IC-R9500
COMMUNICATIONS RECEIVER at the
time of publication.
NEVER
connect the receiver to an AC outlet or to a DC
power supply that uses more than specified. This will ruin
the receiver.
DO NOT
apply an RF signal of more than 20 dBm (100 mW)
to the antenna connector. This could damage the receiver’s
front end.
To upgrade quality any electrical or mechanical parts and
internal circuits are subject to change without notice or
obligation.
MODEL
VERSION FREQUENCY COVERAGE (MHz)
IC-R9500
[USA]
0.005–821.999999,
851.000000–866.999999,
896.000000–3335.000000
[USA-01]
0.005–3335.000000
[EUR]
[UK]
[EXP]
Be sure to include the following four points when ordering
replacement parts:
1. 10-digit order numbers
2. Component part number and name
3. Equipment model name and UNIT name
4. Quantity required
<SAMPLE ORDER>
1110006750 S.IC
TK14570L
IC-R9500
RF-A UNIT
5 pieces
8820001210 Screw 2844 screw
IC-R9500
CHASSIS
10 pieces
Addresses are provided on the inside back cover for your
convenience.
ORDERING PARTS
1. Make sure a problem is internal before disassembling
the receiver.
2.
DO NOT
open the receiver until the receiver is
disconnected from its power source.
3.
DO NOT
force any of the variable components. Turn
them slowly and smoothly.
4.
DO NOT
short any circuits or electronic parts. An
insulated tuning tool
MUST
be used for all adjustments.
5.
DO NOT
keep power ON for a long time when the
receiver is defective.
6.
READ
the instructions of test equipment throughly
before connecting equipment to the receiver.
REPAIR NOTES
INTRODUCTION
CAUTION
Icom, Icom Inc. and the Icom logo are registered trademarks of Icom Incorporated (Japan) in Japan, the United States, the
United Kingdom, Germany, France, Spain, Russia and/or other countries.
