![background image](http://html2.mh-extra.com/html/icom/ic-m506ge/ic-m506ge_instruction-manual_5210073013.webp)
7
3
PREPARATION
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
■
MMSI code entry
The 9 digit MMSI (Maritime Mobile Service Identity: DSC self
ID) code can be entered at power ON.
This initial code setting can be performed only once.
After being set, it can be changed by only your dealer
or distributor. If your MMSI code has already been en-
tered, this procedure is not necessary.
q
Hold down [PWR](Dial) to turn ON the power.
• Three short beeps sound, and “NO DSC MMSI” is displayed.
w
Push [ENT] to start the MMSI code entry.
• Push [CLEAR] twice to cancel the entry, and go to the normal
operating screen. In this case, the transceiver cannot make a
DSC call. To enter the MMSI code, turn OFF the power, then turn
it ON again.
e
Enter your MMSI code in the following manner:
• Select a desired number using [
Y
]/[
Z
]/[
Ω
]/[
≈
].
• Push [ENT] or dial to set it.
• To move the cursor, rotate dial or select either arrow, “
←
” or “
→
,”
then push [ENT] or dial.
r
Repeat step
e
to enter all 9 digits.
t
After entering the 9 digit code, “FINISH” is automatically
selected, and then push [ENT] or dial to set it.
y
The “MMSI CONFIRMATION” screen is displayed.
u
Enter your MMSI code again for confirmation.
• Enter in the same manner as steps
e
through
t
.
i
When your MMSI code entry is successfully completed,
the screen as shown below is briefly displayed.
• After that, the normal operating screen is displayed.
The entered MMSI code can be checked in the MENU screen.
(p. 85)
Summary of Contents for IC-M506GE
Page 1: ...INSTRUCTION MANUAL iM506GE VHF MARINE TRANSCEIVERS iM506...
Page 116: ......