26
TROUBLESHOOTING
10
PROBLEM
POSSIBLE CAUSE
SOLUTION
REF.
The transceiver does not turn
ON.
• The battery is exhausted.
• The battery pack is not attached cor-
rectly.
• Recharge the battery pack.
• Attach the battery pack correctly.
p. 23
p. 3
No sound from speaker.
• The squelch level is too high.
• Volume level is too low.
• Speaker has been exposed to water.
• Set the squelch level to the threshold level.
• Adjust the audio level to a suitable level.
• Drain water from the speaker.
p. 12
p. 11
p. 13
Transmitting is impossible,
or high power can not be se-
lected.
• Some channels are for low power or re-
ceive only.
• The battery is exhausted.
• The battery is over charged.
• The output power is set to low.
• Change channels.
• Recharge the battery pack.
• Make sure the battery voltage is correct.
• Push [Hi/Lo
] to select high power.
pgs. 8,
9, 27
p. 23
—
p. 10
The displayed channel cannot
be changed.
• Lock function is activated.
•
Push and hold [Hi/Lo
] for 1 sec. to
cancel the function.
p. 13
Scan does not start.
• “TAG” channels are not programmed.
•
Set the desired channels as “TAG” chan-
nels.
p. 15
Emits no beep.
• Beep tone function is turned OFF.
•
Set the beep tone to ON (Fix Beep/User
Beep) in the set mode.
p. 18
Battery voltage error.
• The connected battery pack’s voltage is
more than 11 V.
• Make sure the battery voltage is correct.
—
The noise cancellation does
not work.
• The sub-microphone is covered with
something.
• An optional external speaker-micro-
phone is connected.
• Make sure the sub-microphone is not
covered.
• Disconnect the microphone.
p. 4
p. 25
The noise detection function
does not work.
• The sub-microphone is covered with
something.
• The squelch is open.
• Make sure the sub-microphone is not
covered.
• Set the squelch level to the desired level.
p. 4
p. 12