5
P h [PTT] i
h
di
i hibi
i
l
✔
For Trunking mode operation
APCO P25 Mode Operation
5
Push [PTT] to transmit the radio inhibit signal to
the target station.
• The Transmit indicator lights red.
• “PLEASE WAIT” is displayed.
6
Release [PTT].
• “ACK RECEIVED” is displayed after receiving an
acknowledgement from the target station and the
transceiver returns to normal operation
✔
For Trunking mode operation:
This function is available only for a dispatcher in the
Trunking mode.
1
Push [Digital Button] to enter the digital call type
selection mode.
2
Push [CH Up] or [CH Down], or rotate
[CH Up/Down] to select “RDO UINHIBIT.”
transceiver returns to normal operation.
• “NO ACKNOWLDG” is displayed when an
acknowledgement is not received and the
transceiver returns to normal operation.
Receiving
If a radio inhibit signal is received that matches
your Individual ID, you cannot receive or transmit
f
d (D
di
h
l
)
[CH Up/Down] to select RDO UINHIBIT.
3
Push [Digital Button] again to enter the Individual
ID selection mode.
• A pre-programmed ID name is displayed.
afterwards. (Depending on the pre-set value.)
1
When a radio inhibit signal is received;
• The Busy indicator lights green.
• The ringer sounds. (Depending on the pre-
setting.)
• “SORRY” (default) appears.
• When the ID name is not programmed,
the ID code is displayed.
4
Push [CH Up] or [CH Down], or rotate
2
An acknowledgement is automatically
transmitted.
• The Busy/Transmit indicator does not light
because the radio inhibit is activated.
[CH Up/Down] to select the desired ID (or name).
• Push and hold [Digital Button] for 1 sec to
cancel and return to normal operation.
• The ID can be edited with the 10-keypad*.
(Depending on the pre-set value.)
* 10-key models only
5
Push [PTT] to transmit the Radio Uninhibit signal
to the target station
▒
NOTE: The transceiver will not be revived until
▒
one of the following operations is performed.
▒
(Depending on the presetting.)
▒
• Receiving a Radio Uninhibit signal.
▒
• Entering the user passcode.
▒
When the decode action is set to “Kill,” the
▒
cloning operation is necessary to revive.
to the target station.
• The Transmit indicator lights red.
• “PLEASE WAIT” is displayed.
6
Release [PTT].
• “ACK RECEIVED” is displayed after receiving an
acknowledgement from the target station, and
then the transceiver returns to normal operation.
• “NO ACKNOWLDG” is displayed when an
■
Radio Uninhibit function
Transmitting
A Radio Uninhibit function allows you to send a
signal that will revive the inhibited transceiver.
[Digital Button] key assignment is necessary to
transmit the Radio Uninhibit signal.
NO ACKNOWLDG is displayed when an
acknowledgement is not received and the
transceiver returns to normal operation.,
48