Icom, Icom Inc. and logo are registered trademarks of Icom Incorporated (Japan) in the United States, the United
Kingdom, Germany, France, Spain, Russia and/or other countries.
INTRODUCTION
This service manual describes the latest service information
for the
IC-F80DT/DS and IC-F80T/S
UHF TRANSCEIVERS
at the time of publication.
DANGER
NEVER
connect the transceiver to an AC outlet or to a DC
power supply that uses more than 7.2 V. Such a connection
could cause a fire or electric hazard.
DO NOT
expose the transceiver to rain, snow or any liquids.
DO NOT
reverse the polarities of the power supply when
connecting the transceiver.
DO NOT
apply an RF signal of more than 20 dBm (100 mW)
to the antenna connector. This could damage the trans-
ceiver's front end.
ORDERING PARTS
Be sure to include the following four points when ordering
replacement parts:
1. 10-digit order numbers
2. Component part number and name
3. Equipment model name and unit name
4. Quantity required
<
SAMPLE ORDER
>
1130010100 S.IC
LMX2352TM
IC-F80DS Main unit 5 pieces
8810010121 Screw PH B0 M2
×
8 SUS SSBC IC-F80DS Chassis 10 pieces
Addresses are provided on the inside back cover for your
convenience.
REPAIR NOTES
1. Make sure a problem is internal before disassembling the transceiver.
2.
DO NOT
open the transceiver until the transceiver is disconnected from its power source.
3.
DO NOT
force any of the variable components. Turn them slowly and smoothly.
4.
DO NOT
short any circuits or electronic parts. An insulated turning tool
MUST
be used for all adjustments.
5.
DO NOT
keep power ON for a long time when the transceiver is defective.
6.
DO NOT
transmit power into a signal generator or a sweep generator.
7.
ALWAYS
connect a 30 dB to 40 dB attenuator between the transceiver and a deviation meter or spectrum analyzer
when using such test equipment.
8.
READ
the instructions of test equipment thoroughly before connecting equipment to the transceiver.
To upgrade quality, all electrical or mechanical parts and internal
circuits are subject to change without notice or obligation.
MODEL VERSION SYMBOL
APCO25
10-KEYPAD
IC-F80DS
USA-02
[L]
Compatible
No
USA-03
[H]
USA-04
[L]
Not compatible
USA-05
[H]
IC-F80S
USA-06
[L]
FM only
USA-07
[H]
IC-F80DT
USA-02
[L]
Compatible
Yes
USA-03
[H]
USA-04
[L]
Not compatible
USA-05
[H]
IC-F80T
USA-06
[L]
FM only
USA-07
[H]
IC-F80DS/S
fineline6
