![background image](http://html1.mh-extra.com/html/icom/ic-f6011/ic-f6011_service-manual_612637002.webp)
This service manual describes the latest technical
information for the
IC-F6011, IC-F6012, IC-F6013,
IC-F6013H
UHF MOBILE TRANSCEIVERS, at the time of
publication.
NEVER
connect the transceiver to an AC outlet or to a DC
power supply that uses more than the specified voltage.
This will ruin the transceiver.
DO NOT
expose the transceiver to rain, snow or any liquids.
DO NOT
reverse the polarities of the power supply when
connecting the transceiver.
DO NOT
apply an RF signal of more than 20 dBm (100 mW) to
the antenna connector. This could damage the transceiver’s
front-end.
To upgrade quality, any electrical or mechanical parts
and internal circuits are subject to change without notice
or obligation.
MODEL
VERSION
CHANNEL
SPACING
(kHz)
FREQUENCY
RANGE
IC-F6011
USA-01
12.5/25.0
400−470 MHz
USA-02
450−512 MHz
IC-F6012
EUR-02
12.5/20.0/25.0
400−470 MHz
IC-F6013
EXP-01
12.5/25.0
IC-F6013H
EXP-03
EXP-04
450−520 MHz
Be sure to include the following four points when ordering
replacement parts:
1. 10-digit Icom part number
2. Component name
3. Equipment model name and unit name
4. Quantity required
<ORDER EXAMPLE>
1110007320 S.IC
NJM2591V
IC-F6011
MAIN-A UNIT 5 pieces
8820001210 Screw 2438 screw
IC-F6011
Top cover
10 pieces
Addresses are provided on the inside back cover for your
convenience.
ORDERING PARTS
1. Make sure that the problem is internal before
disassembling the transceiver.
2.
DO NOT
open the transceiver until the transceiver is
disconnected from its power source.
3.
DO NOT
force any of the variable components. Turn
them slowly and smoothly.
4.
DO NOT
short any circuits or electronic parts. An
insulated tuning tool
MUST
be used for all adjustments.
5.
DO NOT
keep power ON for a long time when the
transceiver is defective.
6.
DO NOT
transmit power into a Standard Signal
Generator or a Sweep Generator.
7.
ALWAYS
connect a 50 dB to 60 dB attenuator between
the transceiver and a Deviation Meter or Spectrum
Analyzer, when using such test equipment.
8.
READ
the instructions of the test equipment throughly
before connecting it to the transceiver.
REPAIR NOTES
INTRODUCTION
CAUTION
Icom, Icom Inc. and the Icom logo are registered trademarks of Icom Incorporated (Japan) in Japan, the United States, the
United Kingdom, Germany, France, Spain, Russia and/or other countries.