![background image](http://html1.mh-extra.com/html/icom/ic-f4011/ic-f4011_service-manual_4253983009.webp)
4 - 3
4-2-2 MODULATION CIRCUIT
The modulation circuit modulates the VCO oscillating signal
(RF signal) using the audio signals from the microphone.
The AF signals from the D/A converter (IC8, pin 3) change
the reactance of varactor diode (D18) to modulate the oscil-
lated signal at the TX VCO circuit (Q13, D17, D18, D21).
The modulated VCO signal is amplified at the buffer amplifi-
ers (Q10, Q12) and then applied to the drive amplifier circuit
via the T/R switch (D14, D15).
The CTCSS/DTCS signals (“CENC0”, “CENC1”, ”CENC2”)
from the CPU (IC13, pins 23–25) pass through the low-pass
filter (IC5, pins 12 and 14) via 3 registers (R191–R193) to
change its wave form. Then the signals are applied to the
D/A converter (IC8, pin 9). The output signals from the D/
A converter (IC8, pin 10) pass through the low-pass filter
(IC6, pins 6 and 7) to be mixed with “MOD” signal, and then
applied to the D/A converter again (IC8, pin 4).
4-2-3 DRIVE/POWER AMPLIFIER CIRCUITS
The drive/power amplifier circuits amplify the VCO oscillat-
ing signal to a transmit power level.
The modulated RF signal from the TX VCO circuit passes
through the T/R switch (D14, D15) and is amplified at the
YGR (Q9), pre-drive (Q5), drive (Q8), and power (Q7)
amplifiers to obtain 4 W of RF power (at 7.2 V DC).
The amplified signal passes through the low-pass filter (L1,
L2, L45, C1–C5, C175, C176), antenna switch (D2) and
power detector (D1, D30), then applied to the antenna con-
nector (CHASSIS unit; J1).
4-2-4 APC CIRCUITS
The bias current of the drive (Q8) and power (Q7) amplifiers
are controlled by the APC circuit.
The APC circuit (IC2, D1, D30) protects drive and power
amplifiers from the reflected signal, and selects output
power of HIGH, LOW2 or LOW1.
The power detector (D1, D30) detects transmit output power
and converts it into DC voltage. The DC voltage is at a mini-
mum level when the antenna impedance is matched to 50
Ω,
and increased when mismatched.
The detected voltage is applied to the differential amplifier
(IC2, pin 3), and the “T2” signal from the D/A converter (IC8,
pin 23), controlled by the CPU (IC13), is applied to pin 1 for
reference. When antenna impedance is mismatched, the
detected voltage exceeds the power setting voltage. Then
the output voltage of the differential amplifier (IC2, pin 4)
controls the input current of the drive (Q8), and power (Q7)
amplifiers to reduce the output power.
Power
AMP
Differential
AMP
Driver
AMP
+
–
VCC
to ANT unit
T2
TMUT
RF signal
from Buffer AMP
T5V
D1
YGR
AMP
ANT
SW
LPF
LPF
Q8
IC2
Q9
Q7
D2
• APC CIRCUITS