7
NXDN™ OPERATION
7-25
Over The Air Programming nunction (OTAP)
The Over The Air Programming function (OTAP)
enables wireless programming using a transceiver.
Up until now, you needed programming software, a
PC, and a data cable to program transceivers. As the
number of transceivers in a system increased, the
programmimg cost was higher and it took more time
to program.
This function provides easier and faster programming,
and lowers the cost.
TIP:
See the optional CS-OTPM1
otap
manager
software
Help file or its instruction manual for
details.
NOTE:
When using the OTAP function, the following
settings are required in the optional CS-F3400D
programming
software
.
For the OTAP Management transceiver:
When connecting the OTAP Management
transceiver to a PC through the Multi-Connector or a
D-Sub 25 pin connector:
•
Set
Connection Speed
to “19200.”
•
Set
Mode
to “PC CMD V2.”
( Common - External I/O - Option -
Multi-Connector/
D-Sub 25pin
)
When connecting the OTAP Management
transceiver to a PC through a USB port:
•
Set
USB Connection
to “Data Transfer.”
•
Set
Serial Mode
to “PC CMD V2.”
( Common - External I/O - Option -
USB Setting
)
For the SU:
Set
OTAP Accept
to “ON.”
(Digital - OTAP - OTAP Setting -
OTAP Accept
)
PC
(The CS-OTPM1 is installed)
OTAP Managemant
Transceiver
Repeater
Internet
Repeater
L
You can also remotely
program through
repeaters or the Internet.
ICF file
OTAP
data
SU
SU
SU
SU
* SU= Subscriber Unit
Previous view
