Icom IC-F3162T, Insrtuction Manual

Page: 16 / 40

■
Turning power ON
Prior to using the transceiver for the first time, the battery
pack must be fully charged for optimum life and operation.
(p. 19)
q
Rotate [VOL] to turn the power ON.
w
If the transceiver is programmed for a start up password,
input the digit codes as directed by your dealer.
• 10-keypad can be used for password input depending on
version.
• The keys in the table below can be used for password input.
• The transceiver detects numbers in the same block as identical.
Therefore “01234” and “56789” are the same.
KEY
NUMBER
0
5 4
9 3
8 2
7 1
6
(Side1)
P
0
P
1
P
2
P
3
e
When the “PASSWORD” indication does not clear after
inputting 6 digits, the input code number may be incorrect.
Turn the power off and start over in this case.
D Battery type selection
The battery type must be selected according to the attaching
battery type when tuning the transceiver ON.
➥
While pushing and holding [Emer] and [PTT], rotate [VOL]
to toggle the attaching battery type.
• After the display appears, release [Emer] and [PTT].
• “ DRY BATT” is displayed for about 3 sec. then “Lo” (low power
indicator) appears when the battery case operation is selected.
• “LI-ION” is displayed for about 3 sec. when the Lithium-ion bat -
tery operation is selected.
• This operation may not be available depending on the pre-setting.
Ask your dealer for details.
11
3
BASIC OPERATION