4-1
SECTION 4
ADJUSTMENT PROCEDURE
4-1 PREPARATION
■
REQUIRED EQUIPMENT
EQUIPMENT
GRADE AND RANGE
EQUIPMENT
GRADE AND RANGE
Programming
software
CS-F2000 PROGRAMMING
SOFTWARE (Revision 1.31 or later)
Programming cable OPC-478UC
DC power supply
Output voltage:
7.5 V
Current capacity:
More than 2 A
Standard signal
generator (SSG)
Frequency range:
0.1~600 MHz
Output level:
−20 to 90 dBμ
(−127 to −17 dBm)
RF power meter
(50 Ω terminated)
Measuring range:
0.1~10 W
Frequency range:
100~600 MHz
SWR:
Less than 1.2 : 1
AC millivoltmeter
Measuring range:
10 mV to 10 V
Frequency counter
Range:
0.1~600 MHz
Accuracy:
±1 ppm or better
Modulation analyzer
Frequency range:
30~600 MHz
Measuring range:
0 to ±10 kHz
Distortion meter
Measuring accuracy: 3% or less at 1 kHz
Input level:
50 mV to 10 V
Attenuator
Attenuation:
30 dB or 40 dB
Capacity:
More than 10 W
External speaker
Input impedance: 8 Ω
Rated input power:
More than 1 W
Audio generator
(AG)
Frequency range:
300~3000 Hz
Output level:
1~500 mV
Ammeter
Measuring range:
0 to 2 A
Spectrum analyzer Measuring range:
Up to 3 GHz
■
SAVE THE PROGRAMMING DATA
• Adjusting the transceiver will change the programming setting.
• Before adjusting, save the programming data of the transceiver with the programming software.
★
After adjusting, write back the programming data.
■
CONNECTIONS
IC-F2000/IC-F2000S/IC-F2000T
IC-F2000/IC-F2000S/IC-F2000T
Rear panel view
Modulation analyzer
30~600 MHz/0 to ±10 kHz
Spectrum analyzer
Up to 3 GHz
to the antenna connector
Frequency
counter
Standard signal generator
–20 to 90 dBµ
(–127 to –17 dBm)
Loose couple
Attenuator
30 dB or 40 dB
RF power meter
0.1~
10 W/50 Ω
Ammeter
0 to 2 A
DC power supply
7.5 V/2 A
PC
to USB port
OPC-478UC
JIG cable 2:
JIG cable 1:
See the illustration
shown on page 4-2.
To [MIC]
To [SP]
See the illustration
shown on page 4-2.
CAUTION!
NEVER
transmit while
the SSG is connected to
the antenna connector.
