8
4
3
BASIC MANUAL
7
10
15
18
8
13
5
11
16
9
14
6
12
17
1
2
4
BASIC OPERATION
D
Setting the frequency
L
If the transceiver is in the Memory mode,
push [CLR]/[HOME] to exit the Memory
mode.
z
Use the keypad to set the frequency.
Selecting a Memory channel
1. Push [MR]/[MW] to enter the Memory
mode.
•“
” is displayed.
•
The memory channelʼs frequency or
name is displayed, if it is entered.
2. Push [
∫
] or [
√
] to select a channel.
TIP:
To change the selected group:
L
Confirm the transceiver is in the
Memory mode
.
1. Push [FUNC], and then push
[GRP].
2. Push [
∫
] or [
√
] to select a group,
and then push [ENT]/[SET].
D
Receiving
When receiving a signal, “RX” is displayed
and audio should be heard.
L
Rotate [VOL] to adjust the audio output
level.
D
Adjusting the squelch level
z
Push [SQL
∫
]/[SQL
√
] to adjust the
squelch level until the noise just
disappears, when no signal is received.
• The squelch level is displayed while
adjusting.
D
Using the Automatic Noise
Limiter (ANL) function
The function reduces noise components in
the received signal, such as those caused
by engine ignition systems.
z
Push [FUNC], and then push [ANL] to
turn the function ON or OFF.
•“ANL” is displayed while the function is ON.
D
Transmitting
CAUTION: DO NOT
transmit without an
antenna.
z
Hold down [PTT], and then speak at
your normal voice level.
•“TX” is displayed.
NOTE:
When the battery is exhausted,
beep sounds and the transceiver stops
transmitting, even if you hold down [PTT].
■
Selecting the
121.5 MHz
emergency
frequency
In case of emergency, you can immediately
select the 121.5 MHz emergency frequency.
z
Push [FUNC], and then push [121.5] to
select the emergency frequency.
L
Push [CLR] to return to the previously
selected frequency.
■
Receiving and transmitting
