© June 2011 Icom America
9
Programming for 5-Tone Emergency with ID
This procedure enables you to send an emergency signal to a particular radio (or dispatch) and send your
radio’s ID.
The following instructions assume that frequencies, tones, and squelch are set and the radios are in PMR mode
(found in the Menu bar under Model). Additionally, the Auto Reset Timer must be enabled (Memory CH) and a
value entered (Common -> Common). These instructions apply to all Icom radios with PMR capability.
TX Radio
Memory Ch
Field
Setting / Description
ATR
Assign dedicated channel as “E” for emergency
CH Mute
Mute options depend on radio model:
Cont
(not muted) or
SGL
(muted until call is received)
Or
(not muted) or
AND
(muted until call is received)
Switch Action
»
Call
Set to
Audible
5Tone Signaling
»
Form
Set to
EIA
5Tone Signaling
»
STN
Set to 1. Points to 1
st
line in the TX Code CH window: All
Radio’s 5 Tone Emergency code.
5Tone Signaling
»
ID
Set ID on line 28. This is TX radio’s ID code (this radio)
5Tone Signaling
»
POS
Set to
BTM
(Sends STN and ID codes
together
.)
TX Code CH (under 5 Tone):
Field
Setting / Description
Line 1
All Radios’ Emergency Code (Tells other Radios this is
Emergency).
Line 28
TX radio ID (this radio’s ID)
Key and Display (under Common)
Field
Setting / Description
Key
»
Emergency
Assign the emergency key as Emergency Single or
Emergency Repeat.
Common (under Common or Emergency, depending on model)
Field
Setting / Description
Emergency
»
Emer SW ON
Sets how long the emergency key must be pressed to send
an emergency signal
Emergency
»
Emer SW OFF
Sets how long the emergency key must be pressed to
cancel an emergency signal.
Emergency
»
Start/Repeat Timer
Select the delay interval before the radio will send an
emergency signal, and the time between repeat emergency
signals (if emergency repeat is programmed).