This service manual describes the latest technical
information for the
IC-80AD
and
IC-E80D
VHF/UHF
DIGITAL TRANSCEIVER at the time of publication.
NEVER
connect the transceiver to an AC outlet or to a DC
power supply that uses more than specified. This will ruin
the transceiver.
DO NOT
expose the transceiver to rain, snow or any liquids.
DO NOT
reverse the polarities of the power supply when
connecting the transceiver.
DO NOT
apply an RF signal of more than 20 dBm (100 mW) to
the antenna connector. This could damage the transceiver’s
front-end.
To upgrade quality, any electrical or mechanical parts
and internal circuits are subject to change without notice
or obligation.
MODEL VERSION
TYPE OF
EMISSION
Max. TX POWER
(VHF/UHF)
IC-80AD
[USA]
F2D, F3E, F7W
5 W/5 W
[SEA]
[CHN]
[KOR]
[AUS]
[EXP]
IC-E80D
[EUR]
[UK]
[ITR]
[FRA]
Be sure to include the following four points when ordering
replacement parts:
1. 10-digit Icom parts numbers
2. Component name
3. Equipment model name and unit name
4. Quantity required
<ORDER EXAMPLE>
1110003491 S.IC
TA31136FNG IC-E80D/80AD MAIN UNIT 5 pieces
8820001210 Screw 2438 screw
IC-E80D/80AD Top cover
10 pieces
Addresses are provided on the inside back cover for your
convenience.
Icom, Icom Inc. a
ated (Japan) in the United States, the United
Kingdom, German
ORDERING PARTS
1. Make sure that the problem is internal before
disassembling the transceiver.
2.
DO NOT
open the transceiver until the transceiver is
disconnected from its power source.
3.
DO NOT
force any of the variable components. Turn
them slowly and smoothly.
4.
DO NOT
short any circuits or electronic parts. An
insulated tuning tool
MUST
be used for all adjustments.
5.
DO NOT
keep power ON for a long time when the
transceiver is defective.
6.
DO NOT
transmit power into a Standard Signal
Generator or a Sweep Generator.
7.
ALWAYS
connect a 50 dB to 60 dB attenuator between
the transceiver and a Deviation Meter or Spectrum
Analyzer when using such test equipment.
8.
READ
the instructions of test equipment throughly
before connecting a test equipment to the transceiver.
REPAIR NOTES
INTRODUCTION
CAUTION
(IC-80AD)
UNIT ABBREVIATIONS:
F=FRONT
UNIT
L=LOGIC UNIT
M=MAIN
UNIT
V=VCO UNIT
R=RF UNIT
