![background image](http://html2.mh-extra.com/html/icom/ic-7100/ic-7100_basic-manual_3602293038.webp)
3
BASIC OPERATION
3-6
BAND
REGISTER 1
REGISTER 2
REGISTER 3
1.8
MHz*
1
1.900000
MHz CW
1.910000
MHz CW
1.915000
MHz CW
3.5
MHz*
1
3.550000
MHz LSB
3.560000
MHz LSB
3.580000
MHz LSB
7
MHz
7.050000
MHz LSB
7.060000
MHz LSB
7.020000
MHz CW
10
MHz*
1
10.120000
MHz CW
10.130000
MHz CW
10.140000
MHz CW
14
MHz
14.100000
MHz USB
14.200000
MHz USB
14.050000
MHz CW
18
MHz
18.100000
MHz USB
18.130000
MHz USB
18.150000
MHz USB
21
MHz
21.200000
MHz USB
21.300000
MHz USB
21.050000
MHz CW
24
MHz
24.950000
MHz USB
24.980000
MHz USB
24.900000
MHz CW
28
MHz
28.500000
MHz USB
29.500000
MHz USB
28.100000
MHz CW
50
MHz*
1
50.100000
MHz USB
50.200000
MHz USB
51.000000
MHz FM
144 MHz
145.000000
MHz FM
145.100000
MHz FM
145.200000
MHz FM
430 MHz
*
1
433.000000
MHz FM
433.100000
MHz FM
433.200000
MHz FM
General*
1, 2
15.000000
MHz USB
15.100000
MHz USB
15.200000
MHz USB
*
1
The default frequency and mode settings differ depending on the version. Above list shows the USA version’s.
*
2
[GENE] selects the general coverage band.
Using the band stacking registers
D
The triple band stacking register provides 3 memories
for each band key to store frequencies and operating
modes.
This function is convenient when you operate 3 operat-
ing modes on one frequency band.
For example, one register can be used for a CW fre-
quency, another for an SSB frequency and the other
one for an RTTY frequency.
If a band key or [GENE] is touched for 1 second once,
the last used frequency and operating mode are called
up. When the key is touched for 1 second again, anoth-
er stored frequency and operating mode are called up.
See the table below for a list of the available frequency
bands and their default frequency and mode settings.
Select the frequency band you want to use.
Touch the MHz digits of the frequency readout to en-
q
ter the Band selection screen.
Touch a desired operating band, “1.8” to “430” or
w
“GENE.”
• After touching the band, the display moves to the se
-
lected band, and returns to the frequency display.
• Touch a band for 1 second to select the Band stacking
register, Register 1, Register 2 or Register 3 on the Band
selection screen.
• Touch [F-INP] to enter the Direct input screen. (p. 3-11)
• If desired, touch [
](
D
) or push
MENU
(
C
) to exit the
screen.
Selecting a frequency band
The
L
,
R
,
C
or
D
in the instructions indicate the
part of the controller.
L
: Left side,
R
: Right side,
C
: Center bottom
D
: Display (Touch screen)
• Band selection screen
Enters the Direct
input screen
Example: Touch “21” in the above screen
Cancel edit
Operating mode
Touch the MHz
digits.