Icom IC-7000, Service Manual, Page: 22 / 92

4-4 TRANSMITTER ADJUSTMENT (Continue)
ADJUSTMENT ADJUSTMENT CONDITION DISPLAY OPERATION
TX OUTPUT
POWER (HF) 1 • Connect an RF power meter to
[ANT1] connector.
• Connect an audio generator to
[MIC] connector and set as;
Level : 1.5 kHz/30 mV
• Transmitting
Po Min(HF) Set the output power to 1 W using [DIAL].
Then push [F-4 (SET)] .
2 Po Tune(HF) Set the output power to 10 W using
[DIAL]. Then push [F-4 (SET)].
3 Po 25%(HF) Set the output power to 25 W using
[DIAL]. Then push [F-4 (SET)].
4 Po 50%(HF) Set the output power to 50 W using
[DIAL]. Then push [F-4 (SET)].
5 Po(HF APC Low Volt) Set the output power to 75 W using
[DIAL]. Then push [F-4 (SET)].
6 Po 100%(HF) Set the output power to 95 W using
[DIAL]. Then push [F-4 (SET)].
7 Po Max(HF) Set the output power to 105 W using
[DIAL]. Then push [F-4 (SET)] key.
APC (HF) 1 APC(HF) Push [F-4 (SET)].
TX OUTPUT
POWER (AM) 1 • Connect an RF power meter to
[ANT1] connector.
• Apply no audio signal to [MIC]
connector.
• Transmitting
AM POCV Ratio Set the output power to 35 W using
[DIAL]. Then push [F-4 (SET)].
TX OUTPUT
POWER
(50 MHz) 1 • Connect an RF power meter to
[ANT1] connector.
• Connect an audio generator to
[MIC] connector and set as;
Level : 1.5 kHz/30 mV
• Transmitting
Po Min(50 M)
Set the output power to 1 W using [DIAL].
Then push [F-4 (SET)].
2 Po Tune(50 M) Set the output power to 10 W using
[DIAL]. Then push [F-4 (SET)].
3 Po 25%(50 M) Set the output power to 25 W using
[DIAL]. Then push [F-4 (SET)].
4 Po 50%(50 M) Set the output power to 50 W using
[DIAL]. Then push [F-4 (SET)].
5 Po 100%(50 M) Set the output power to 90 W using
[DIAL]. Then push [F-4 (SET)].
6 Po Max(50 M) Set the output power to 100 W using
[DIAL]. Then push [F-4 (SET)].
4 - 7