A-7340H-1EX
© 2016 Icom Inc.
1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan
PANEL DESCRIPTION
D
About the Status indicator
•Lights red while transmitting.
• Lights green while receiving a signal, or when the squelch
is open.
[Emer]
[P1]
[P2]
[VOL/PWR]
[Back]
[PTT]
Status
indicator
Microphone
Function
Display
Ten-Key
Pad
[F2]
[F3]
[F1]
Speaker
[Up]/[Down]
[Right]/[Left]
[OK]
D
Connecting the HM-218
Connect the HM-218 to the optional RMK-5
separation
kit
using the OPC-2373 or OPC-2374
separation
cable
.
See the RMK-5 instruction manual for details.
D
Turning ON the transceiver
1. Connect the microphone cable to the separation
cable’s MIC connector, as shown below.
2. Push [VOL/PWR] on the HM-218 to turn ON the
transceiver.
RMK-5
HM-218
To the MIC
connector
[VOL/PWR]
Separation
cable
CONNECTION
OPTIONS
D
Cables
• OPC-2373, OPC-2374
separation
cables
for command microphones
OPC-2373: 1.9 m : 6.3 ft
OPC-2374: 8 m : 26.3 ft
Some options may not be available in some countries.
Ask your dealer for details.
MICROPHONE INSTALLATION
You can install the microphone and the separation cable on a wall as a wall socket using the supplied mounting base
and self-tapping screws.
Mounting
base
Screw holes
(approximately 2 (d) mm :
5
/
64
inch)
Nut
Separation
cable
1. Drill a hole 24 to 27 (d) mm (
15
/
16
to 1
1
/
16
inches) where
you want to install the mounting base.
2. Attach the separation cable to the mounting base, and
then attach the nut.
3. Using the mounting base as a template, mark the
holes where the three screws will be placed.
4. Drill the screw holes at the marks.
5. Attach the mounting base with the supplied screws, as
shown to the far right.
NOTE:
• You can only attach the HM-218 to the RMK-5’s front
panel.
• You cannot attach the HM-218 to the transceiver’s control
head.