8/19/2011
5
Mixed Analog Repeating
A repeater set for mixed analog is capable of receiving both digital and analog signals, and will re-transmit in
the format received. The front hand mic will transmit in Analog.
Program your radio with the following settings. All frequencies need to be entered and the squelch level must
be set before programming the following settings.
Common Window
Field
Setting / Description
Others
>
Digital Function
Set to
Enable
. When enabled, the
Digital
window appears.
Hold Timer
Set to desired repeater Hang Time.
Memory CH Window
Multiple Table Window
Field
Setting / Description
Table No.
Set to desired number. Can have as many as 16 tables. If you
have created more than 1 table, entering a number in this field
will bring up the matching table.
Type
Set to
Analog
or
Digital
.
Decode
/
Encode
Set to the desired CTCSS tone or RAN code set. Note: RAN
codes are decimal.
Field
Setting / Description
Operation Mode
Set to
Repeat
.
Frequency (MHz)
Enter RX and TX frequencies
Text
Enter appropriate text for the channel name.
RF PWR
Set the desired power level. Choices are
L1
(5W),
L2
(25W),
and
High
(50W).
CH Type
Set to
Mixed-Ana
. This allows receiving in analog and digital
and transmitting the same format as was received.
CW ID
>
ON/OFF
Set to ON (the CW window contains the timers and ID).
TX C Tone
If the
Multiple Table
is
not
enabled, tones apply to TX only; RX
is open squelch. The front hand mic uses this TX tone.
If RX and TX tones are required, use the
Multi Table
to set the
tones.
Multi Table No.
Set to the desired number. It points to the tone/RAN settings in
the
Multiple Table
screen. The repeater will RX and TX for the
assigned channel using the tone/RAN sets referenced in this
window. Note: if there is no value entered, the radio will RX on
any tone and transmit on the tone entered in the
TX C. Tone
field or, if set to
Digital
, will have no RAN for RX or TX.
TX RAN
No function in Mixed Analog Mode.