22
Program Settings
This section defines all of the enhanced feature settings for your radio. In most cases, the default settings will work
best.
Memory CH Window
Field
Description
Suggested Setting
RX RAN
This is the receive digital code that must match the TX radio
RAN before squelch will open. The range is 0 to 63, with 0
representing open squelch.
User Preference
TX RAN
This is the transmitted digital code that must match the RX
radio RAN before squelch will open. The range is 0 to 63, with
0 allowing a match to any RAN code.
User Preference
Unit ID
The unique identification for an individual radio.
User Preference
Talkgroup ID
The unique identification for a Talk Group.
User Preference
Squelch Type
If set to
OFF
, there is only carrier squelch. If set to
RAN
, the
digital RAN code must match before a squelch will open. If set
to
Sel
, the RAN and the Unit ID or Talk Group ID must match
before squelch will open.
User Preference
Digital/Option Window
Field
Description
Suggested Setting
Send Data
Allows the radio to send digital data, in the form of
status messages or GPS data. Set to
Status
to send
status messages following a voice call. To use the
Status feature, you must also program
Send Status
Number
to the desired status message.
User Preference
Sentence
Sets the GPS sentence format. Choose between
RMC
.
GGA
, and
GLL
. When GPS is selected in the
Send Data
field, received position data is transmitted
in the selected GPS format at the end of a call.
Select the format that
matches your
equipment.
Send Status Number
This selects the status message to be sent when the
Send Data
field is set to
Status
.
User Preference
Talkgroup Display on
Mode Change
Enables the Talk Group ID or Zone to display on the
radio when changing the channel or zone.
User Preference
Talkgroup Display on
Receive
Allows the receiving radio to display the Talk Group of
the transmitting radio.
User Preference
Unit ID Display on
Receive
Allows the receiving radio to display the Unit ID of the
transmitting radio.
User Preference
Ringer on Receive
This sets the ringer type (Pi, Po, single, repeat, etc.)
when receiving a call.
User Preference
Talkgroup Display on
PTT
When you select a Talk Group and press PTT, the
selected Talk Group ID will show on your radio’s
display.
User Preference
Over Ringer
Enables a short beep in the receiving radio at the end
of a transmission.
User Preference
TX R.T.T Beep
Enables two short beeps in your radio when it is
ready to transmit (R.T.T).
User Preference
