Configuration Mode
OFF
1 . Verify the SC4211 is in the
OFF
mode .
Press the
SYS
(left) button until off mode displays .
2 . Remove the cover of the thermostat by gently pulling near one of the
corners at the top of the thermostat .
3 . Press the
CONFIG
button for 1 second while the SC4211 is in
OFF
mode .
To exit configuration mode, press the
CONFIG
switch for 1 second .
Press the
up
or
down
button to change settings within each screen .
Down
button
Up
button
Press the
right
button to advance to the next screen .
Note:
Pressing the
left
button will return you to the previous screen .
Left
button
Right
button
The configuration mode is used to set the SC4211 to match your heat pump system .
To configure the SC4211, perform the following steps:
CONFIG
S1 S2 R
C
W
O/B
G
Y1 W2
W3
Y2
RESET
CONFIG
FP
