REFERENCE DIAGRAM
05
DRIVER SIDE example
below:
ICI STEP INSTALLATION
Step 1 (Prep)
Beginning on the Driver's side,
remove any steps if equipped.
Next, locate the 3 sets of
mounting points on the
underside of the vehicle.
Please note that your
Jeep will
have
OE factory
U-clip Nuts
located in the underside floor
holes
,
fig. 1.
Leave attached
and reuse for instalation.
Figure 1.
Step 3 (Hang bar
on Brackets)
Next, locate the driver side bar
,
the distance from the front of
the bar to the first step hoop is
greater than the distance from
the rear of the bar to the
second step hoop, reference
the diagram on page
4
.
The top
of the bar has a
small lip, use
the lip to hang the
bar on the
brackets. This will
make the
installation process
easier and
hands-free.
Figure 2.
Step 2 (Install
Brackets to
Jeep
)
Begin with the driver front bracket
1005
4
9
, loose fit
. For the 2 pinch
weld holes, you will need (2 sets) of
M6x25mm hex head bolt
s,
M6
Nylock Nuts, and (
2
) of M6x22x2mm
flat washers. Use a 10mm socket.
For the floorboard hole, you will
need (1 set) of M8x28x3mm flat
washer, M8 lock washers, and
M8x35mm hex head bolts. Use a
13mm socket. Once the front
bracket is attached, move on to the
middle bracket, then the rear
bracket, repeating the steps above.
Figure
3
.
1005
4
9
Front
Bracket
1005
5
0
Middle
Bracket
1005
5
1
Rear
Bracket
DRIVER SIDE example
below:
04
