General information
18
THERMOREGULATION AND MESSAGE DISPLAY
Thermoregulator front
1
Instructions:1 =2nd stage of burner on (enabled to work)2 =Burner on (enabled to work)
2
Display of flow temperature measured or indication of the variable during the thermoregulator parametrization phase (HSET
- SP - AL2 - HAL2)
3
Display of the burner AL2 (ON-OFF variable) or of the sets of variables during the thermoregulator parametrization phase
(HSET - SP - AL2 - HAL2)
4
Enter key, its pressure allows accessing variable parametrization and if you push it again it scrolls the sequence of variables(HSET
- SP - AL2 - HAL2)
5
Up and down keys for the variables during the thermoregulator parametrization
Variable functions
HSET = Set Point hysteresis(working temperature hysteresis, burner 2nd stage control)
SP= Set Point(working temperature, burner 2nd stage control)
AL2= Limit temperature set(burner ON-OFF control)
HAL2= Limit Set hysteresis(limit temperature hysteresis, burner ON-OFF control)
NOTE:
in case of a panel with e-therm, refer to the relevant manual.
Cooke Industries - Phone: +64 9 579 2185 Email: [email protected] Web: www.cookeindustries.co.nz
