406DUO V1.2.0
Synchronous Balance Charger/Discharger
- 13 -
Program Add & Manage
Click
STOP/START-x
button on the initial interface to pop up the
BATTERY MEMORY SELECT
window.
406DUO has 7 built-in programs
before it enters to the market (shown in the following picture), which cannot be deleted
and are limited for editing. The built-in programs are underline to distinguish them from the customized programs set by
the user.
Click "
" (or long press
KNOB
)
to pop up the
MANAGE
after exiting focus via pressing
TAB/SYS
, and click
"
" to enter
MEMORY SETUP
to edit the program, or click "
" to add new program and
enter its editing interface at the same time.
Note: If the program selected is a built-in program,
"Copy From
…" and "
Delete"
options are shown in
grey as inactive status, and unable to be set.
Run Program for Charger
After selecting program on
BATTERY MEMORY SELECTION,
click to enter
Run Program
interface (long press
STOP/START-x
button
on the initial interface will enter
Run Program
from the last running program), as below:
Note: 1. The revised common parameters of built-in program will be saved by default automatically
after running, while the program customized by the user can be set to be saved or not in
MEMORY SETUP
→
MEMORY OPTION
→
Auto save before the program runs.
2. After setting the Cap. value, when the Current value exceeds the certain value, the system will
be a warning display and alarm voice(shown in the following picture). The Current value of
each battery type is: LiXX battery :> 3C,
NiMH/NiCd
battery :> 2C, Pb battery :> 0.3C, NiZn
battery>2C.
1: Run Program Selection
2: Common Parameters Setup
3. Auto- save Hint
1
2
3
