iCharger 3010B User Manual Download

Page: 19 / 32

-19-

iCharger Synchronous Balance Charger/Discharger 3010B

Charge-to-discharge & Discharge-to-charge cycle mode for a Lithium battery

Lithium battery in monitoring mode

When you use other devices to charge or discharge Lithium pack, the

iCharger

can monitor each cell‘s

voltage, battery temperature, charge time and so on, if one of the batteries appears over-charged,
over-discharged, over-hot, over-capacity or over-time ,the

iCharger

will alarm with noise

“Di…..”

and blink

the raleted information.

Note

: when in Li monitor Mode, no need connecting the main port if connecting the balance port.

Charging/discharging cycle mode of Lithium battery.
The left side of the first line sets the type of battery (LiPo, Lilo or LiFe) and
the  right  side  shows  the  cycle  number.  The  second  line  shows  the  cycle
direction  you  selected:  (C:  x.xxV->D:  x.xxV)  or  (D:  x.xxV->C:  x.xxV),  the
value  of  the  second  line  sets  the  final  charge/discharge  voltage.  Press

Start/Enter

button for more than 3 seconds with a sound ‖Di‖ to start the

next process.

Cycle number: 1

–

999

(only last 10 times cycle information will be

displayed)

Voltage: LiPo (3.00

–

4.20V), Lilo (2.50

–

4.10V), LiFe (2.00

–

3.60V)

The number of cells you set and the processor detects. If the checking
result is the same, it would enter to the next interface; if not the same, the
left side of the first line ‘R: xxSER‘ shows the number of cells detected by
the

iCharger

and the right side of the first line ‘S:xxSER‘ is the number of

cells set by the user. You should make sure that the configured number and
the actual number for the battery are the same and then you can start
charging by pressing

Start/Enter

. If not, press

Batt type/Stop

to go back to

the previous screen and adjust the setting.

Charging/discharging cycle mode of Lithium battery.
In this process, you can stop the cycle at any time by pressing the

Batt

type/Stop

button. In the process of C>D or D>C, the blink ―C‖ indicates

charging, while ―D‖ indicates discharging. Press

Inc



button to display

each cell‘s voltage and its past cycling current (see the balance voltage
information& cycling information) and press



Dec

button to display the

General Status information.
During the waiting time of discharge-to-charge cycle mode, you can stop
the waiting process with pressing ―Start" button for three seconds!

LiPo MONITOR
3.0V 11.1V(3S)

Monitor mode of Lithium battery. The left side of the first line sets the type of
battery (LiPo, Lilo or LiFe). The value on the right side of the second line
sets the low limit of voltage and the battery pack number. After setting the
current and voltage press

Start/Enter

button for more than 3 seconds with

a sound ‖Di‖ to start the next process.

Individual alarm low-Vt: final discharging voltage to the highest
charging voltage (such as: LiPo 3.0V

–

4.2V),

Battery series: 1

–

10 series

The monitor information, in this process; you can stop monitoring process at
any time by pressing

Batt type/Stop

button