16
1. Unpack the ice storage bin and make sure that it will not be
moved after installation.
2. Connect the drain hose at the bottom outlet part and fully tighten
the joints at the connecting part in order to minimize leaks.
3. Adjust the 4 adjustment feet of the storage bin to level it.
(Adjustment must be less than 1
。
for all 4 feet)
1. Put the support (bracket) into the gap of the bin
as shown in the right picture.
(Please make sure that the hook of the bracket
is hung on the gap of the bin firmly,
so it won't be fallen out.)
2. Open the bin door and check the two holes
location on the right side.
Make sure to match the hole location of the support (bracket)
with the two holes of the bin and fix it with screws.
3. Bins without the two holes, please see followed instruction ;
Make a 6mm diameter hole on the 25mm
from the notching part of the inside panel
and another hole on the 115mm from the
notching part as shown on the right picture.
Please use, this time, the support (bracket)
WITHOUT the hook and fix it.
(Please contact your supplier or the manufacturer
for the bracket without the hook.)
※
Please contact the supplier or the manufacturer when needed further assistance.
How to install the storage bin
Storagebin support installation
Tighten the joints at the connecting part, face the outlet
of the hose upward, and pour some water into the bin
to check for leaks.
STORAGE BIN
STORAGE BIN
SUPPORT
(BRACKET)
SUPPORT
(BRACKET)
115
25
NOTCHING PART
WITH HOOK
WITHOUT HOOK
(ASK THE SUPPLIER
OR THE MANUFACTURER)
