IceTech KG30 SUPREME, Manual

Page: 14 / 116

MANUAL for KG30 - KG50 SUpreMe
dr
y
ice bl
a
sting
equipm
ent
fro
m
ic
etech
|
Page 12
“ The operator must NEVER repair the
blasting hose without using original IceTech
spare parts!! ”
SHUTTINg DOWN THe DRY ICe BLaSTINg MaCHINe
When the cleaning task has been completed, the
following procedure must be carried out before the
machine is dismantled or stored:
• Empty the hopper.
• Activate the trigger on the blasting gun
for a few seconds in order to empty the system
of possible dry ice residue.
• Close the compressed air supply.
• Activate the trigger on the blasting gun for a few
seconds in order to depressurize the system.
• Turn off the machine (press the red OFF button).
• Disconnect the main power supply.
• Disconnect the compressed air supply.
• It is recommended to disconnect the
blasting hose.
CORReCT ORDeR IS IMPORTaNT!
FIRST disconnect the signal cable – THeN the
blasting hose couplings!!
• Avoid kinking the blasting hose, when rolling
it up.
eMeRgeNCY STOP
activation of the emergency stop button immediately
stops the blasting air stream and the dry ice flow.
before the machine can be restarted, the following
procedure must be carried out:
• Disengage the emergency stop button
(pull out the button).
• Start the machine (press the green ON button).
• Restart the blasting air stream by activating
the trigger switch on the blasting gun.
PReCaUTIONS – BLaSTINg HOSe
Connection and Disconnection
Never disconnect the blasting hose from the ma-
chine or blasting gun when the main power supply
and/or compressed air supply are connected. other-
wise activation of the trigger on the blasting gun will
result in a discharge of blasting air through an open
outlet instead of through the blasting gun nozzle.
if this happens, the operator will lose control of the
air stream, and serious injury may result.
CORReCT ORDeR IS IMPORTaNT!!
• Connection:
FIRST connect the blasting hose couplings
– THeN the signal cable!!
• Disconnection:
FIRST disconnect the signal cable
– THeN the blasting hose couplings!!
Defective Blasting Hose
the outer hose sleeve protects the operator from
any exposure caused by wear and tear of the inner
hose. no pressure build-up is permissible in the outer
sleeve during operation.
if a defective blasting hose is used, the operator
risks serious injury from being hit by dry ice pel-
lets.
Any sign of inflation means that the inner hose is in
some way defective.
NOTE:
If that fault occurs, stop the machine
IMMEDIATELY:
• Close the compressed air supply immediately.
• Activate the trigger on the blasting gun
until the system is depressurised.
• Activate the emergency stop button.
• Disconnect the main power supply.
• Disconnect the compressed air supply.
• Disconnect the blasting hose
( FIRST disconnect the signal cable
– THeN the blasting hose couplings).
• Make sure the blasting hose is repaired and
pressure-tested (see following page).
• Although the hopper may not be empty, the
system must not be blasted through until a
new/repaired blasting hose has been connected.