6
Rev. 6
Figure 2: TMS Mounted
7.
Confirm the gasket is properly installed to the Ice Qube TMS. This gasket is required to create a
seal against your enclosure and will maintain enclosure integrity.
(See Gasket and Cutouts pg 21)
Mechanical Installation Instruction
Caution: Protective safety clothing such as helmet, gloves, and steel toe shoes are recommended.
1.
Position the Ice Qube TMS so that the two mounting studs are in alignment with the top two 3/8”
(9.5mm) holes or the hanging tabs align properly with the cutout, depending on model, in your
enclosure surface.
2.
Slide the Ice Qube TMS mounting studs through the 3/8” (9.5mm) or 1/2" (12.7mm) depending on
model, holes in your enclosure and check to see that all openings are aligned.
3.
After checking that all openings and bolt holes are in alignment, assemble and tighten the (2 or 4)
¼”-20 nuts and (2, 4, 6 or 8 depending on model) ¼”-20 x 1” bolts supplied with you Ice Qube
TMS by hand. Check to ensure gasket will properly seal the Ice Qube TMS to your enclosure.
4.
Using a wrench, tighten the nuts and bolts until the gasket between the heat exchanger and the
enclosure is compressed to a maximum thickness of 1/8” (3.175mm). Check the entire perimeter
of the gasket/enclosure interface for compression and seal.
5.
Mechanical installation is now complete. Continue with the electrical installation of the Ice Qube
TMS.
Ambient Side
Enclosure Side
Summary of Contents for IQ10000HE
