5
that refrigerant tubes are not damaged during transportation and the
installation of the appliance. In the event that the refrigerant circuit is
damaged, avoid naked flames or sources of ignition and ventilate the room
in which the appliance is situated.
Do not damage the refrigerant circuit.
Do not allow children to play with the appliance. Children must never
play in or around the appliance.
If using an adaptor, this must be used in accordance with the
manufacturers instructions and ensure that the electrical circuit is not
overloaded as this could cause overheating.
Do not twist or bend the cables, and keep them away from hot surfaces.
Do not plug ın or unplug
this appliance with wet hands.
Following installation make sure that the power cable is not trapped
underneath the appliance.
Section 3. Operating the Appliance
3.1. Switching on the Appliance
Allow the appliance to stand for a minimum of 4 hours after installation.
Plug in the appliance and switch on at the mains supply.
Set the thermostat control to the required setting as detailed in the
Temperature Control section (3.2.).
Leave the appliance for approximately 4 hours for the correct
temperature to be reached.
3.2. Temperature Control
The temperature control dial is located adjacent to the ice box and can be
adjusted by rotating the dial in a clockwise direction from ‘0’ to ‘6’.
Setting ‘Off’: Appliance switched off
Setting ‘1’: Warmest Temperature
Setting ‘3’ to ‘4’: Normal Operation (adequate for most situations)
Setting ‘6’: Coldest Temperature
Important!
During high ambient temperatures e.g. on hot summer days, it may be
necessary to set the thermostat to the coldest setting. This may cause the
compressor to run continuously in order to maintain a low temperature in the
cabinet.
3.3. Ice-Box
The ice-box can be used for the freezing and storage of small amounts of ice.
Please note: You cannot use this ice-box to store frozen food or freeze
any fresh food item.
