8
Section 1. Installation
-
IMPORTANT!
This appliance must be left to stand in an upright position
for at least 4 hours before being switched on for the first time.
-
Remove all packaging and securing tape from the appliance.
-
Wash the interior of the appliance with luke warm water containing a
small amount of bicarbonate soda (5ml to 0.5 litres of water).
-
Position the appliance in a dry atmosphere and out of direct sunlight.
-
Do not position next to a cooker or other sources of heat, i.e. radiator.
-
This appliance should not be sited in a cold atmosphere, i.e. garage or
shed. Doing so may cause the freezer unit to underfreeze.
-
If positioned next to another fridge or freezer, leave a minimum gap of
2cm between the appliances in order to avoid condensation.
-
A clearance of 50mm should be left above the appliance. If this cannot
be achieved you should ensure a clearance of 25mm is maintained on
each side of the appliance.
-
Fit the plastic wall spacers to the condenser on the rear of the
appliance, this will ensure an air gap between the appliance and the
wall.
-
Do not place or store heavy items on the top of this appliance.
-
Ensure that the appliance is positioned on a firm flat floor.
-
This appliance must be level. Adjust the level by screwing the
adjustable feet up or down (use your fingers or a suitable spanner).
-
Ensure that the appliance is upright and both feet are in firm contact
with the floor so that the cabinet is stable.
-
Connect the plug to an adjacent 13amp socket outlet and ensure that
the appliance is not standing on the supply cable.
Summary of Contents for FF218WE
Page 20: ...CKICK D01 K ...
