TRANSPORTATION INSTRUCTIONS
The appliance should be transported only in a vertical upright position. The packing as
supplied must be intact during transportation.
If during the course of transport the product has been transported horizontally, it must
only be laid on its left hand side (when facing the door front) and it must not be operated
for at least 4 hours to allow the system to settle after the appliance is brought back to
upright position.
1. Failure to comply with the above instructions could result in damage occuring to the
appliance. The manufacturer will not be held responsible if these instructions are
disregarded.
2. The appliance must be protected against rain, moisture and other atmospheric
influences.
IMPORTANT:
Care must be taken while cleaning / carrying the appliance to avoid
touching the condenser metal wires at the back of the appliance, as you might injure your
fingers and hands or damage your product.
IMPORTANT:
This appliance is not designed for stacking with any other appliance. Do
not attempt to sit or stand on top of your appliance as it is not designed for such use. You
could injure yourself or damage the appliance.
IMPORTANT:
Make sure that mains cable is not caught under the appliance during and
after carrying / moving the appliance, to avoid the mains cable becoming cut or
damaged.
”
When positioning your appliance take care not to damage your flooring, pipes, wall
coverings etc. Do not move the appliance by pulling by the lid or handle. Do not allow
children to play with the appliance or tamper with the controls. Our company declines to
accept any liability should the instructions not be followed.
INSTALLATION INSTRUCTIONS
1.
If possible avoid placing the appliance near cookers, radiators or in direct sunlight as
this will cause the compressor to run for long periods. If installed next to a source of
heat or refrigerator, maintain the following minimum side clearances:
From Cookers 4" (100 mm)
From Radiators 12" (300 mm)
From Fridges 4" (100 mm)
2.
Make sure that sufficient room is provided around the appliance to ensure free air
circulation. Ideally, A space of no less than 10cm must be left around the freezer, and
ensure you allow gaps as shown in the below diagram.
Summary of Contents for CF300W
Page 1: ...CF300W...
