5
6
3
Don't cross the fuse of the device,
directly connect to the battery.
)
The installation of the device
1 First of all, take the original vehicle CD player out.
2 Remove the install bracket and screws and keep it.
3 Fix the bracket through the screws on the navigation system device.
4 Don't connect this product power wire directly to other power-line circuits.
5 Fix all the cables according to the hose diagram.
6 Install the navigation system in right position and then screw the bracket of the
original car to fix it well.
)
)
)
)
)
)
(Picture-01)
Note:
Do not damage or dirty the Dashboard.
The installation of GPS antenna
GPS antenna
metal plate please peel
the paper at back
please sweep the
place to make sure
no dust,wet,oil or dirt
before you stick.
:
N
t
OTE he metal plate
have powerful glutinosity to
leave the impress when you
remove it.
(Picture 02)
-
1) To install the antenna in the inner of
the car(on the rear shell),please try to make
the metal plate stick on the horizontal lever
so that the GPS antenna towards the
window. GPS antenna will be placed on the
metal plate. ( GPS antenna fixed by
magnetic.) picture 02
(
-
)：
When the lead contacts the up
of the car door to circle au-turn
in order to prevent the rain water
flows along the lead to the in-
house of vehicle.
G
PS Antenna
Waterproof mat
Please make sure water-
proof mat to contact the
top of rubber pad.
Curving the lead to a circle
out side the rubber pad in
order to prevent rain water
flows along thelead vehicle
in-house.
(Picture 03)
-
2 To install an external antenna (on the
car),GPS antenna will be placed in a level
position as far as possible, such as roof or
cover suitcase Department. ( By a fixed
magnetic body.) picture 03
)
(
-
):
NOTE:
Paste the metal plates, should not be cut it into small pieces. Some models
of vehicles do not allow glass windows GPS satellite signal penetration. Then,
the GPS antenna should be installed at the outside of the vehicle.
Before the Operation
Before the Operation
System installation
Voltage rating
(as the picture -01)
1
This product use for the vehicle with 12V battery and negative GND. Before
the installation, check the battery voltage.
2 In order to avoid short-circuit system, installed prior to the proposed removal
)
)
of the battery negative.
